A screw extractor is a tool for removing broken or seized screws. There are two types: one has a spiral flute structure, commonly called an easy out after the trademarked name EZ-Out; the other has a straight flute structure. Screw extractors are intentionally made of hard, brittle steel, and, if too much torque is applied, can break off inside the screw that is being removed. Since the extractor is an extremely hard material, and a typical home shop drill bit will not be able to drill into it, a larger element of difficulty is added to the original screw extraction project. One way to avoid this added difficulty is to drill a hole completely through the screw. Thus, if the fastener breaks, a punch can be used to drive out the easy out from the screw, via the back, or end, of the fastener.
Spiral fluted extractor
Screw extractor | easyout | broken bolt removal - Get screw extractors here http://fave.co/1LU8x19 Screw extractors are often called easyouts, these can be used to remove a broken bolt or a broken stud from a tapped hole. Here we demonstrate...
A spiral screw extractor is itself a coarse-pitched tapered screw thread. They are generally left-handed, for use on right-handed threads, though there are right-handed extractors for removing left-handed screws.
The screw is first drilled out to the proper diameter for that extractor. The extractor is then inserted into this hole and turned in the direction opposing the stuck screw's original one, usually using a tap wrench. As the extractor is turned, the flutes on the tool dig into the screw, causing it to lock tightly and withstand the applied torque required to remove the screw.
A drawback to tapered screw extractors is that their wedge action tends to expand the drilled, and thus weakened, screw. This wedging action can lock the screw even more tightly in place, making it difficult or impossible to extract.
Straight fluted extractor
Straight fluted extractors may come in a kit that also has associated drills, drill bushings, and special nuts, or be sold individually. The screw is drilled out with the appropriate drill and drill bushing. The extractor is then hammered into the hole with a brass hammer, because a steel hammer is more likely to cause the extractor to break. The appropriate special nut is then attached to the end of the extractor. The nuts can then be turned with a wrench to remove the screw.
Straight fluted extractors have less wedging effect than tapered screw extractors, so have less tendency to lock the screws into place. A further form is a parallel fluted extractor, with no taper at all and thus no wedging. These work well, but have the drawback of requiring the pilot hole to be drilled to a precise size. This size is often non-standard for most drill sets, requiring a dedicated drill bit to be supplied with the kit.
Bolts
While screws are often colloquially referred to as bolts, they are not the same. While screws thread into parts, bolts are used to join two non-threaded parts, typically using a nut. A screw extractor would not be used to remove a bolt because it is not threaded into the parts. A tool analogous to a screw extractor, but for removing a seized or rounded off nut from a bolt, would be a nut extractor, which has tapered, spiral flutes like a screw extractor, but located internally in the tool, not externally. These flutes or grooves grip the rounded nut from the outside, rather than being driven into the hollowed out screw shaft and taking hold of it internally as a screw extractor would. Another tool for a stuck nut on a bolt, but not a screw, is a nut splitter.
References
